Toro 79487 Manual page 3

ROPS Kit
TimeCutter
Model No. 79487—Serial No. 400000000 and Up
Store this document with the Operator's Manual for the traction unit.
Safety
Rollover Protection System
(ROPS) Safety
•
The ROPS is an integral safety device. Do not
remove any of the ROPS components from the
machine.
•
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
•
Keep the roll bar in the fully raised and locked
position and always wear your seat belt whenever
the roll bar is up.
•
Check carefully for overhead objects before you
drive under them, and do not contact them.
•
Replace damaged ROPS components. Do not
repair or alter them.
•
There is no rollover protection when the roll bar
is down.
•
Wheels dropping over edges, over steep banks, or
into water can cause a rollover, which may result
in serious injury or death.
•
Do not wear the seat belt when the roll bar is down.
•
Lower the roll bar only when absolutely necessary;
raise it as soon as clearance permits.
•
In the event of a rollover, take the machine to an
Authorized Service Dealer to inspect the ROPS.
•
Use only Toro approved accessories and
attachments for the ROPS.
© 2024—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Max or Titan ® Riding Mower
Safety and Instructional
Decals
Register at www.Toro.com.
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
107-3069
1. Warning–there is no rollover protection when the roll bar is
down.
2. To avoid injury or death from a rollover accident, keep the
roll bar in the fully raised and locked position and wear
the seat belt. Lower the roll bar only when absolutely
necessary; do not wear the seat belt when the roll bar is
down.
3. Read the Operator's Manual; drive slowly and carefully.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3465-735 Rev A
Installation Instructions
decal107-3069
*3465-735*