Table of Contents
Advertisement
UNCR ATING (CONT.)
6. Remove the condensate drain pan. Set the drain
pan aside. See fig. 9.
7. Slightly raise the rear leveling leg rollers. Turn the
front adjustment screw 1/4-1/2 turn clockwise.
See fig. 10.
8. With assistance, pull the unit off the back of the
pallet. Then, remove the pallet and Carefully guide
the unit to a fully upright position. See fig. 11.
CAUTION!
equipment from the unit's sides, never
the front or rear. See fig. 12. Failure to
do so may result in personal injury or
appliance damage. Do not lift the unit by handles,
doors, or hinges.
1
2
FIG. 11b.
Then, tilt the unit
backward and remove the skid.
Page 28 of 64
T RUE RE S ID E N TI A L
I N S T A L L A T I O N
Only lift with appliance moving
FIG. 11c.
Carefully guide the
appliance to an upright position.
®
FIG. 9.
Remove the drain pan before pulling the appliance off the skid.
adjustment screw
FIG. 10.
Adjustment screw location. Other adjustment screw not shown.
FIG. 11a.
With assistance, carefully walk the appliance partially off the
back of the skid.
FIG. 12.
Only lift with appliance moving equipment from the SIDES,
NEVER
the
FRONT
or REAR.
10/18/2023
P# 848062
1/4 – 1/2 turn
shipping bracket
TEC_TM_170 REV. B
Advertisement
Table of Contents
