Table of Contents
Advertisement
ELEC TRIC AL SAFE T Y
Power Supply: 115VAC, 60hz
Circuit Breaker: 15 Amp
Receptacle: 3-Prong Grounding-Type
• For all built-in models, the electrical supply should
be located within the indicated shaded area shown
in the figure below.
• Be sure to follow the National Electrical Code, as
well as local codes and ordinances, when installing
the receptacle.
• A ground fault circuit interrupter (GFCI) is not
recommended and may cause interruption of
operation.
• The power cord from this appliance is equipped
with a grounding plug which minimizes the
possibility of electric shock hazard.
• The wall outlet and circuit should be checked by a
licensed electrician to be sure the outlet is wired
with the correct polarity and properly grounded.
• If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with a properly grounded wall outlet.
•
DO
NOT, under any circumstances, cut or remove
the ground prong from the power cord. For personal
safety, this appliance must be properly grounded.
• The refrigerator/freezer should always be plugged
into a dedicated electrical circuit. This provides
the best performance and prevents building wiring
circuits from overloaded, which could cause a fire
hazard from overheated wires.
TEC_TM_170 REV. B
P R I O R T O I N S T A L L A T I O N
P A G E T I T L E
•
•
• Before your new unit is connected to a power
•
• When moving the refrigerator/freezer for any reason,
• Immediately repair or replace all power cords
• If the supply power cord is damaged, replace it
10/18/2023
NEVER USE AN ADAPTER PLUG!
An adapter plug alters the original
equipment manufacturer (OEM) plug
configuration when connecting it
to a power source. True will not warranty any
refrigerator/freezer that has been connected to an
adapter plug.
NEVER USE AN EXTENSION CORD!
extension cord is any component that
adds length to the OEM power cord
when connecting it to a power source.
True will not warranty any refrigerator/freezer that
has been connected to an extension cord.
supply, check the incoming voltage. If the recorded
voltage is less than the rated voltage for operation
(+/-5%) and amp rating, correct immediately. Refer
to the serial label for this voltage requirement.
NEVER
unplug your refrigerator/freezer by pulling
on the power cord. Always grip the plug firmly and
pull straight from the outlet.
take care to no roll over or damage the power cord.
that have become frayed or otherwise damaged.
DO NOT
use a power cord that shows cracks or
abrasion damage along its length or at either end.
with OEM components. To avoid hazard, this should
be done by a licensed service provider or similarly
qualified person.
T RUE 42 /4 8 IN STA L L M A NUA L
An
Page 13 of 64
Advertisement
Table of Contents
