Advertisement
Available languages
Available languages
The air compressor is now ready for use.
BEFORE EACH START-UP
1.
Every day check the sight glass to ensure that the level of
oil in the pump is at the required level.
2.
Place Auto/Off switch to "OFF (0)".
3.
Close the drain valve.
4.
Visually inspect air lines and fittings for leaks.
5.
Check safety valve. See Check Safety Valve under
Maintenance.
6.
Turn the regulator knob counterclockwise to set the outlet-
pressure to zero.
7.
Attach hose and accessories.
WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when
installing or disconnecting to prevent hose whip.
WARNING: Risk of unsafe operation. Do not use damaged or worn
accessories.
NOTICE: The hose or accessory will require a quick connect
plug if the air outlet is equipped with a quick connect socket.
DANGER: Risk of bursting. Too much air pressure causes a hazardous
risk of bursting. Check the manufacturer's maximum pressure rating for
air tools and accessories. The regulator outlet pressure must never exceed
the maximum pressure rating.
CAUTION: Risk of unsafe operation. Compressed air from the unit may
contain water condensation and oil mist. Do not spray unfiltered air at an
item that could be damaged by moisture. Some air tools and accessories
may require filtered air. Read the instructions for the air tools and
accessories.
HOW TO START
1. Turn the Auto/Off switch to "AUTO (1)" and allow tank pres-
sure to build. Motor will stop when tank pressure reaches
"cut-out" pressure.
2. Turn the regulator knob clockwise to increase pressure.
NOTICE: When using a regulator and other accessories refer to
the manufacturer's instructions.
DANGER: Risk of bursting. If any unusual noise or vibration is noticed,
stop the air compressor immediately and have it checked by a trained
service technician.
The air compressor is ready for use.
SHUT-DOWN (Fig 5)
1. Move Auto/Off switch to the OFF (0) position.
NOTICE: When finished using air compressor, follow Steps 2 - 7.
2. Drain the tank, see Draining Tank under Maintenance. En-
sure tank pressure gauge reads 0 PSI (0 kPa).
DANGER: Risk of unsafe operation. Firmly grasp air hose in hand when
installing or disconnecting to prevent hose whip.
16
Advertisement
