Table of Contents
Advertisement
– bottom gasket of the drain
tap,
Assembly after cleaning
1. Before assembly the components, clean the evaporator tube and drip hoses
without using any scouring agents.
EN
2. Flush the tank gasket with water before reinstalling the tank gasket to make tank
reassembly easier.
3. Put the tank gasket in place on the back of the evaporator tube.
4. Once the tank gasket is in place, use your thumbs to press down on the bottom
and then gradually down the top (make a circle with your fingers) until it is
properly seated. (Fig. 33, 34)
26 / 32
Fig. 31
Fig. 33
Fig. 32
– tank gasket.
Fig. 34
Cleaning
135022
Advertisement
Table of Contents
