Graco 24J415 Instructions-Parts List Manual page 15

Units
Ratio of Depending on system
the Blue / setup the units can be
Red mate- by weight or volume
rial - set-
point
Pump Red PSI, bar, or MPa
Pressure -
Actual
Pump PSI, bar, or MPa
Blue Pres-
sure -
Actual
Pump Depending on system
Flow - setup the units can be
Actual by weight or volume
Ratio of Depending on system
the Blue / setup the units can be
Red mate- by weight or volume
rials
-Actual
Dispense Depending on system
Amount - setup the units can be
Actual by weight or volume
Dispense mS
Duration
-Actual
Blue Inline Depending on system
Temp - setup the units can be
Actual read in C or F
Blue Hose Depending on system
Temp - setup the units can be
Actual read in C or F
Red Inline Depending on system
Temp - setup the units can be
Actual read in C or F
3A1704H
CGM Input
In from PLC Out
Byte Output Byte
-- -- 23-24 Integer value
-- -- 25-28 Integer value
-- -- 29-32 Integer value
-- -- 33-36 Integer value
-- -- 37-38 Integer value
-- -- 39-42 Integer value
-- -- 43-46 Actual Dura-
-- -- 47-48 Actual tem-
-- -- 49-50 Actual tem-
-- -- 51-52 Actual tem-
CGM Output
to PLC Input
Monitoring Only. The value from the
of the Blue / CGM is an integer and must be mul-
Red Material tiplied by 0.01 for the requested
Ratio setpoint material Ratio to be in system units
in the dis- Blue is the value and Red is always
pensing sys- = 1. Blue: Red == xx.xx:1
tem.
Monitoring Only. The value from the
of the actual CGM is an integer and must be mul-
Red pump tiplied by 0.0001 for the actual Red
pressure in pump pressure to be in system units
the dispens-
ing system.
Monitoring Only. The value from the
of the actual CGM is an integer and must be mul-
Blue pump tiplied by 0.0001 for the actual Blue
pressure in pump pressure to be in system units
the dispens-
ing system.
Monitoring Only. The value from the
of the actual CGM is an integer and must be mul-
Flow rate in tiplied by 0.0001 for the actual flow
the dispens- rate to be in system units
ing system.
Monitoring Only. The value from the
of the actual CGM is an integer and must be mul-
Material Ratio tiplied by 0.01 for the Actual material
in the dis- Ratio to be in system units. Blue is
pensing sys- the value and Red is always = 1.
tem. Blue: Red == xx.xx:1
Monitoring Only. The value from the
of the actual CGM is an integer and must be mul-
Dispense tiplied by 0.001 for the actual
amount in the amount to be in system units
dispensing
system.
Monitoring Only. Time base is 0.001
tion of the dis- seconds == xxx ms.
pense in mS
Monitoring Only. The value from the
perature CGM is an integer and must be mul-
tiplied by 0.1 for the actual tempera-
ture to be in system units.
perature
perature
Available Internal Data
Descriptions
15