Table of Contents
Advertisement
2.2 HEAT OUTPUT ADJUSTMENT
The valve supplied with the appliance has a HI/LO knob to control the heat output and
flame height (see valve diagram in lighting instructions section 2.1)
2.3 BASIC FAN OPERATION
For units equipped with a fan control knob, the knob is located in the valve control compartment and
may be adjusted to the following settings:
OFF: Turn the control fully counter-clockwise until the switch operates.
Variable Speed Setting:
Turn the control to the desired setting. When the knob is turned fully clockwise the fan will set to
minimum speed.
Electrical Grounding Instructions / Instructions à la terre électrique
This appliance is equipped with a three prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded
three prong receptacle. Do not cut or remove the grounding prong from this plug.
Cet appareil est équipé d'une broche de trois (terre) pour votre protection contre
les risques d'électrocution et doit être branchée directement sur une prise trois
broches réceptacle. Ne pas couper ou enlever la terre volets de cette fiche.
WARNING
AVERTISSEMENT
Installation of any type of filter on the fan is not admissible and could
result in a fire, explosion, property damage, serious personal injury, or
L'installation de tout type de filtre sur le ventilateur n'est pas recevable et
pourrait provoquer un incendie, d'explosion, des dégâts matériels, des
death.
blessures graves ou la mort.
(60Hz )
To Wall Switch or Rheostat
Page 13 of 57
Advertisement
Table of Contents
