GE Typhoon 9200 Operating Instructions Manual page 63

5 Maintenance
5.7 Replacement of fuses
Changing fuses in the Image
eraser
You can use the Image eraser with either a 220–240 V (230 V) power source or a 100–
120 V (115 V) power source. The selected operating voltage of the Image eraser appears
in the fuse window on the right side of the Image eraser, next to the power switch (Image
eraser‚ on page 11).
To change a fuse in the Image eraser, follow the instruction below.
1
2
3
4
5
6
7
62
Turn off the Image eraser and disconnect the power cord.
Note the voltage (115 V or 230 V) showing in the fuse window (Fig 5-2 A).
A B C D
Opening the fuse box of the Image eraser.
Figure 5-2.
Place the end of a small flathead screwdriver in the small groove (Fig 5-2 B) above
the fuse window and pry to open the fuse box.
Place the screwdriver in the groove (Fig 5-2 C) on the upper edge of the fuse holder
(Fig 5-2 D) and pry out the fuse holder. When the holder is loose, pull it out of the
fuse box.
One or both fuses might be blown. Replace the blown fuse(s) with new fuse(s) of the
same type and rating. Fuse specifications are listed in Section 7.1 and on the label
located on the unit.
Insert the fuse holder into the fuse box making sure the correct voltage rating for
your power supply is right side up.
Snap the cover of the fuse box back into place. Check that the correct voltage
rating for your power source appears in the voltage window. If the voltage is
incorrect for your power source, remove the fuse holder, rotate the holder 180° so
that the correct voltage rating is right side up, and reinsert the fuse holder.
Typhoon Operating Instructions 28-9623-56 AA