Checking Wheel Bolt Torque - Kubota L3540 Operator's Manual

[HST Type]
C Test: Switch for the speed control pedal.
1. Sit on the operator's seat.
2. Depress the speed control pedal to the desired
direction.
3. Depress the clutch pedal fully.
4. Disengage the PTO clutch control switch or lever.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the PTO clutch control switch or
lever.
1. Sit on the operator's seat.
2. Engage the PTO clutch control switch or lever.
3. Depress the clutch pedal fully.
4. Place the speed control pedal in neutral position.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the clutch pedal.
1. Sit on the operator's seat.
2. Disengage the PTO clutch control switch or lever.
3. Place the speed control pedal in neutral position.
4. Release the clutch pedal.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the operator's seat.
1. Sit on the operator's seat.
2. Start the engine.
3. Engage the PTO clutch control switch or lever.
4. Release the parking brake.
5. Stand up. (Do not get off the machine.)
6. The engine must shut off after approximately 1
second.
7. If it does not stop, consult your local KUBOTA Dealer
for this service.
PERIODIC SERVICE
(1) Speed control pedal
(2) Clutch pedal
(3) PTO clutch control lever
BChecking Wheel Bolt Torque
To avoid personal injury:
A Never operate tractor with a loose rim, wheel,
or axle.
A Any time bolts and nuts are loosened, retighten
to specified torque.
A Check all bolts and nuts frequently and keep
them tight.
Check wheel bolts and nuts regularly especially when
new. If they are loose, tighten them as follows.
(1) [L3540, L4240] 137 N-m (14 kgf-m)
[L5040, L5240, L5740] 185 N-m (19 kgf-m)
(2) 215 N-m (22 kgf-m)
93