Table of Contents
Advertisement
The electric socket flap closes automatically in
the following situations:
shortly after the charging cable connector has
R
been removed
after the socket flap has been tapped in the
R
direction to close it
after transmission position i, h or k has
R
been engaged
Automatic backing up function of the electric
socket flap
If an obstacle impedes the electrical socket flap
while it is closing, the socket flap will open again
automatically. The automatic backing up function
is only an aid and is not a substitute for your
attentiveness.
When closing the socket flap, make sure that
#
no body parts or objects are in the closing
area.
Function of the charge level display in the driver's
display
%
The data shown in the illustration is example
data.
1
Range at current charge level
2
Current state of charge of the high-voltage
battery
3
Maximum state of charge (depending on the
setting)
4
Time remaining until completely charged (until
the selected maximum charge level is
reached)
5
Charge level recommended by Range Assis-
tant to reach the next destination
6
Dynamic charge level display
7
Current charging capacity
Driving and parking 215
%
Specified remaining range
1
may vary due to
different factors, e.g. driving style or topogra-
phy.
When the vehicle is connected to the mains sup-
ply and is switched off, the driver's display shows
the charge level display for approximately two
minutes.
%
The value of current charging capacity
differ from the display on the charging station.
At a charging capacity of 10 kW or higher, the
value in the charge level display is rounded off
and shown without a decimal place.
The value in
4
varies depending on the setting of
the charging process. It displays the charging pre-
diction, e.g. the time at which the selected charge
level will be reached or the charge level at the
pre-selected departure time.
7
can
Advertisement
Table of Contents
