Table of Contents
Advertisement
Adaptive Highbeam Assist Plus automatically
switches between the following types of light:
Low-beam headlamps
R
Partial high beam
R
High beam
R
ULTRA RANGE Highbeam
R
ULTRA RANGE Highbeam increases the bright-
ness of the cone of light to the legally permitted
maximum.
Partial high beam does not include other road
users in the high beam area. It does not dazzle
them but enables full high-beam illumination for
the driver apart from the excluded vehicles. Highly
reflective signs are also illuminated with reduced
brightness.
At speeds below 16 mph (25 km/h) or when
there is sufficient street lighting:
Partial high beam and high beam will be
R
switched off automatically.
At speeds greater than 19 mph (30 km/h):
If no other road users are detected, high beam
R
will switch on automatically.
If other road users are detected, partial high
R
beam will switch on automatically.
at speeds below 25 mph (40 km/h):
The ULTRA RANGE Highbeam will switch off
R
automatically.
Light and visibility 153
At speeds above 31 mph (50 km/h):
If no other road users are detected, the road is
R
straight and it is not raining heavily, the ULTRA
RANGE Highbeam will be switched on auto-
matically.
If other road users are detected, partial high
R
beam will switch on automatically.
If highly reflective signs are detected, ULTRA
R
RANGE Highbeam will be switched off auto-
matically.
%
The system's optical sensor is located behind
the windshield near the overhead control
panel.
▌Switching Adaptive Highbeam Assist Plus
on/off (Canada)
Switching on
Turn the light switch to the à position.
#
Switch on high beam using the combination
#
switch.
If Adaptive Highbeam Assist Plus is activated,
the _ indicator lamp will light up on the
driver's display. When partial high beam or
Advertisement
Table of Contents
