Skier's Choice Supra Boats SV 2024 Owner's Manual page 71

Connecting your trailer
When connecting the trailer to your tow vehicle, use the following procedure:
1. Raise the tongue with the trailer jack. Position the trailer coupler directly over the tow vehicle ball, and
lower the jack until the coupler goes all the way down over the ball.
2. Ensure that the coupler latch top is fl ush with the coupler and has closed over the ball. If it does not
automatically close, press down on it until it closes.
3. Insert the locking pin into the coupler. Lock pin hole is on the side of
the coupler.
4. When all weight is off the trailer jack, pull the jack lock pin and rotate
the jack to the horizontal position and re-lock the pin.
5. Attach the safety cables to the tow vehicle hitch. Cross the cables
and wrap them around each other once or possibly twice allowing and wrap them around each other once or possibly twice allowing
just enough slack to permit tight turns of the vehicle and trailer.
6. Plug the trailer lights connector to the vehicle harness.
7. Clip the brake lockout cable to the vehicle hitch.
NOTICE: If your hitch ball has an excessive fl at spot on top, the latch may
not engage properly. If the latch does not catch, check with your dealer
or hitch installer before trailering.
Trailer Alignment
Trailer Plug Wire Schematic
White: Ground
Green: Right Turn/Brake
Yellow: Left Turn/Brake
Brown: Running Lights
Blue: Reverse Lights
Correct Trailer Alignment
When pulling the boat onto the trailer, be
sure that it is centered on the trailer.
Incorrect Trailer Alignment
The distance between the boat and the
wheel runner board should be equal on
both sides.
Pg 139