Skier's Choice Supra Boats SV 2024 Owner's Manual page 58

Dripless Shaft Seal
Your Supra comes standard with a dripless shaft seal. If any
seepage occurs, contact your dealer.
Component Lubrication
Normal use of your Supra causes metal to metal movement at
some parts in the boat. These moving parts should be lubricated
with a water resistant chassis lubricant such as silicon grease.
Water Strainer
The engine water strainer is a fi lter for the engine cooling water.
It consists of a stainless steel mesh fi lter inside a clear cup. It is
located between the water intake on the bottom of the boat and
the engine's raw water pump. It should be checked periodically
for debris as conditions dictate. To remove debris, unscrew the
clear sight cup, remove the o-ring and stainless steel mesh fi lter
and proceed to rinse out the cup. Be sure to reinstall the mesh
fi lter and o-ring before reattaching the sight cup to the inlet.
Fresh Water Flush
The Fresh Water Flush port on the water strainer is a valve specifi cally designed to allow you to attach a garden
hose to your engine water intake to fl ush brackish or salt water out of your engine. To use the Fresh Water Flush,
simply attach a garden hose to the valve. Turn on the water to the valve. Start the engine. Monitor the exhaust
port on the transom of your boat and engine temperature gauge. Water should come out of the exhaust port
while the engine is running. It is recommended that you run the engine at a low RPM while fl ushing, since the
engine's raw water pump at higher RPMs can pump more water than the garden hose can supply. If you have
questions on the operation of your Fresh Water Flush port, consult your Supra Dealer.
Pg 113