Disassembly Of Drive System - Baoli CPDS15 Operation & Service Manual

1.1.2 Front wheel assy
The front wheel is made up of rim and solid tyre. The types of the tyre and rim of the
front wheel:
Tyre size: 18×7-8
Rim: 4.33R

1.2 Disassembly of drive system

Before disassembling the transmission case, disassemble the front wheel assy and
traction motor joint with it, then you can do maintenance and service on the parts of
transmission case.
1.2.1 Removal of wheel (Fig.1-2)
Drain the oil from the transmission case
before disassembling the wheel. Loosen the
wheel nuts and remove the drive wheel, then
loosen the 7 bolts fixing in the frame and remove
the transmission case joint with traction motor
from the frame.
1.2.2 Disassembly of traction motor (Fig.1-3)
Remove the three bolts for traction motor
(1×M10×50 and 2×M10×90, Pos.1 and 2).
NOTICE:
· Take off the traction motor from the
transmission case cautiously.
· In case of the removal of the traction from the
transmission case, there is a danger to damage the
sealing surface of the o-ring in the housing. If only
removing the motor, seal the released transmission
opening to avoid the dirt from entering into the
transmission case.
1.2.3 Disassembly and assembly of transmission case
Outer diameter × Width = 457×170 (mm)
20
Fig.1-2
Fig.1-3