Table of Contents
Advertisement
hydraulic system and its components because of excessive pressure passing them.
(42) According to the Directive 2000/14/EC and based on EN12053 standard，when
the forklift truck during the test of lifting, traveling and idling, but the noise of the forklift truck
may fluctuate due to different operation and the influence of the external environment.
(43) The driver feels the vibration of the forklift truck when operating and traveling the
forklift truck. According to ISO3691 and based on EN13059 standard. The vibration of the
forklift truck fluctuates according to environment condition. In normal working condition, the
vertical direction acceleration mean value from the seat to the operator is referred to the
following table. But the vibration frequency felt by the driver depends on the working
condition (etc. road, operation method), so the actual vibration frequency must be
determined according to environment condition when necessary.
Model
CPDS15-18
(44) Users select "Lengthening fork" in order to carry widening loads. Pay much
attention not to overload and observe the allowable load and the capacity chart on the truck.
Careful driving should be taken when traveling and turning.
(45) When operating the machine, observe and follow all markings on the machine.
The marking plates must be replaced if lost or damaged on time.
(46) The forklift truck must be used under the following environment: below an
elevation of 1000 meters and temperature between -15℃ and 35℃, relative humidity is 95%.
Careful operation must observe under other adverse circumstances.
(47) To prevent the fire, accident or other unpredictable event, prepare the fire
extinguisher in advance and operate it according to the instructions.
(48) You can't change or add other working equipments on the truck without our
company's permit, or the rated capacity and safety operation will be affected.
(49) Check for the fastener of overhead guard, lift-descend device, adjust the roller
clearance and do the lubrication maintenance, check the chain, pulley and do the
lubrication maintenance, and lower the device to the lowest position. Please pay more
regard to safety when maintaining the upper mentioned parts for that they are on high
position.
2.5 Periodic servicing and maintenance of electric forklift truck
The noise pressure level at
the operator's position
EN 12053
78.9dB(A)
The vertical direction acceleration mean
value from the seat to the operator
8
EN 13059
2
0.87(m/s
)
Advertisement
Table of Contents
