Hardware Requirements And Precautions; Hardware Installation Procedure - Raidon InTANK Series User Manual

Hide thumbs Also See for InTANK Series:
Table of Contents

Advertisement

iR2024S User Manual

3. Hardware Requirements and Precautions

1. Computers or servers must be with SATA I, SATA II, or SATA III.
2. Hard drive must be with SATA I, SATA II, or SATA III.
3. Once the drive mode configuration has been completed, re-configuration using the same hard
drives to set the drive mode will result in complete data loss. If you must change the drive mode,
make sure to backup all data prior to the mode change.
4. All existing data will be deleted when this product is set up for the first time. Please ensure that all
data on the hard disk has been backed up before installation to avoid data loss.
5. Please make sure that the two hard drives are free from bad blocks or defects prior to installation
in order to avoid system crashes or data loss.
6. The usable storage capacity of the hard disk after formatting will be less than the capacity
indicated on the hard disk.
7. It is highly recommended for user to back up important data contained within the iR2024S unit on
a regular basis or whenever the user feels necessary to a remote or a separate storage device.
RAIDON will not be responsible for any lost of data caused during the use of the unit or the
recovery of the data lost.

4. Hardware Installation Procedure

Please follow the instructions below to complete the hardware installation.
Step 1
After unlocking the HDD tray key lock with the key attached to the accessory, push the
HDD tray ejection to the right and the removable drive tray will pop open to remove the
removable tray.
Step 2
Install the 2.5-inch hard disk and secure it
with the small screws included in the 4 parts
package.
Step 3
When the hard drive installation has been
completed, insert the hard drive tray into the
system horizontally and secure the latch into
place.
Step 4
Install device into one of the CD-ROM bays
with screws from the accessory kit. Then
properly connect SATA cable and SATA power
cable from your system to the device.
Lock
Unlock
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intank ir2024s

Table of Contents