Washing Procedure - Royal Enfield CLASSIC 350 Owner's Manual

WASHING PROCEDURE

PRECAUTIONS
Remove ignition key and seal the ignition key barrel

slot using adhesive tape.
Please remove tool kit, first aid kit and other

relevant documents if any inside the right side
panel before proceeding for washing of the
motorcycle.
Cover the silencer tail pipe, horn and control

switches with suitable plastic bags and tie if firmly
to prevent water entry.
Wash the motorcycle only when the engine is in

cold condition.
Do not remove side panel while washing to avoid

water entry.
Royal Enfield All New Classic 350/Signals 350
83
Brush engine area with a recommend non corrosive

solvent to remove dirt or grease.
Use low pressure water jet to clean.

Never spray water with great force on head lamp,

meter / cluster unit, flasher lights, front and rear
wheel hubs, electrical connections and wires,
control cables, EFI components, spark plug,
battery, side panels.
Do not use high pressure washers or steam jet

cleaners near the seal of headstock bearing or
steering stem bearing, seal of wheel bearing, brake
calipers, air intakes & exhaust outlets.
Do not apply any corrosive solvent on painted

surfaces or rubber parts.