Table of Contents
Advertisement
WASHING PROCEDURE
PRECAUTIONS
Remove ignition key and seal the ignition key barrel
slot using adhesive tape.
Please remove tool kit and other relevant
documents if any inside the right side panel before
proceeding for washing of the
motorcycle.
Cover the silencer tail pipe, horn and control
switches with suitable plastic bags and tie if firmly
to prevent water entry.
Wash the motorcycle only when the engine is in
cold condition.
Do not remove side panel while washing to avoid
water entry.
Royal Enfield HUNTER 350
86
Brush engine area with a recommend non corrosive
solvent to remove dirt or grease.
Use low pressure water jet to clean.
Never spray water with great force on head lamp,
speedometer, tripper, flasher lights, front and
rear wheel hubs, electrical connections and wires,
control cables, cables, sparkplug, battery, ABS
ECU, EMS ECU, side mirrors, steering stem etc.
Do not use high pressure washers or steam jet
cleaners near the seal of headstock bearing or
steering stem bearing, seal of wheel bearing, brake
calipers, air intakes & exhaust outlets.
Do not apply any corrosive solvent on painted
surfaces or rubber parts.
Advertisement
Table of Contents
