Washing Procedure - Royal Enfield SCRAM 411 2021 Owner's Manual

WASHING PROCEDURE

PRECAUTIONS
1. Wash motorcycle when the engine is cold.
2. Cover the silencer. tail pipe, horn, control switches,
instrument cluster & tripper with suitable plastic bags and
tie it firmly to prevent water entry.
3. Remove ignition key and seal key hole using adhesive tape.
4. Brush engine area with a solvent to remove dirt or grease.
5. Use low pressure jet of water to clean.
6. Do not spray water directly on the steering stem area as
it will damage the bearings and course the handle bar
movement to become sticky.
7. Never spray water with great force on head lamp,
speedometer, flasher lights, front and rear wheel hubs,
90 Royal Enfield Scram 411
electrical connections and wires, control cables, cables,
sparkplug, battery, ABS ECU, EMS ECU, side mirrors, steering
stem etc.
8. Do not apply any corrosive solvent on painted surfaces or
rubber parts.
9. Use luke warm water and mild detergent on the painted
components to remove dirt, etc.
10. Rinse motorcycle thoroughly with plain water to remove the
detergent.
11. If possible, use compressed air and blow off water particles
from the hard to reach areas of the motorcycle, electrical
connections etc.
12. No direct jet at the edges of decal, electrical parts, coupler
joints, silencer tail pipe, radiator lubrication points like steering
cone kit, brake pedal, wheel bearings, chain, brake cam & swing
arm bushes to be washed in spray mode only (not in jet mode).