Table of Contents
Advertisement
b e
u s t
e m
m m
d g
4 5
g .
i s e
t 1
l i n
T h
e a s
c e i
a t l
t h e
m
f r o
30 mm
30 mm
20 mm
Tape
2 3
2 0
g u
st
A u
d ,
ite
L im
ir a
r M
h le
K o
©
7 -A
2 -W
9 8
5 4
1 5
Position the installation template to the desired location on the wall and secure with
the tape.
Note: Use a spirit level to ensure the installation template is vertical.
Mark and drill the wall fixing positions for diverter wall plate and riser bar fixing brackets
(Ideally this should be in the centre of a tile and not on a grout line.). When drilling
the tiles ensure this is done in the middle or towards the bottom of the marked slots.
Caution! DO NOT drill into cables or pipes in the wall.
Insert the wall plugs and secure the diverter wall plate and riser bar fixing brackets
using the screws supplied.
For Airboost version, continue directly to the Airboost Version section.
8 mm
Upper Riser Fixing Bracket
8 mm
Diverter Fixing Kit
Important! DO NOT allow the overhead or handset spray
water directly on to an electric shower. The overhead
and handset must be positioned so this does not occur.
We recommend that the diverter wall plate should be installed
not more than 0.3 metre away (Refer to image on page 8)
(this is to ensure that the shorter interconnecting hose can be
connected) from shower outlet.
Note: A special longer 1.2 metre hose is available as a
spare part if the position of the shower fittings cannot
be installed as shown. Contact Mira Customer Service.
Important! Short bottom
riser bar is available as
an accessory. Contact
Customer Services for
assistance.
9
8 mm
Lower Riser Fixing Bracket
1555018-W2-A
Advertisement
Table of Contents
