Table of Contents
Advertisement
Locking Peg
on top side
Concealing
Cover
Mounting
Boss
Locking Peg
on underside
Notches (x5)
Grubscrew
Diverter
Notches (x5)
Offer the riser bar assembly and the
diverter to the three wall fixing brackets. If
necessary, adjust the wall bracket position
to the correct places.
Remove the riser bar assembly and fit the
concealing covers onto each of the riser
bar wall brackets.
Slide the diverter over the wall plate
ensuring the notches in the diverter lines
up with the notches on the wall plate.
Push the lower bar and middle bar mounting
boss onto the wall fixing brackets until it
clicks into place.
Important! Ensure that the locking peg
clicks in and is fully engaged in the
hole in the mounting boss. Pull gently
on riser bar to confirm the locking
pegs are engaged.
Assemble the grubscrew (shown) to secure
the diverter.
15
1555018-W2-A
Advertisement
Table of Contents
