Table of Contents
Advertisement
Back Panel
① Analog Audio Input
Three-pin, low-voltage differential input connector adds line- or aux-level analog signals for sound reinforcement.
Note: This input is meant for balanced connection. If an unbalanced source is used, such as an IPOD or MP3 player, only use pins 1 (signal) and 3 (ground) of
the block connector. See the Specifications section for wiring diagrams.
② Chassis Ground Screw
Provides an external connection point to the chassis ground of the device.
③ Analog Audio Output
Connect to a signal processor, amplifier, or recording system. OUT1 provides the full mix (all audio inputs), OUT2 provides
mix-minus (far-end audio inputs only, minus local audio).
④ USB-C Audio
Connect to a laptop, videoconferencing unit, or control device.
⑤ Power
USB-C power connector, for use with included 5V 3A power supply.
⑥ Ethernet Ports
Connect to external control software, or Dante audio network.
⑦ Reset Button
Press and hold for 5-8 seconds to reset network settings.
Press and hold for more than 8 seconds to reset the device to factory default settings.
Software
Control Software for MXW neXt
The MXW neXt access points feature a control software to manage the audio inputs and outputs of the MXW neXt system.
When logging in for the first time, you can set a password to restrict access, or choose to continue with no password. Set or
change the password from Settings > Permissions.
Note: For optimal system performance, the control software should not be open to more than seven tabs or windows.
Shure Incorporated
12/41
Advertisement
Table of Contents
