Table of Contents
Advertisement
Indications
Validity Check Light
Sense Bit 4-Data Check
(If stacker selection is delayed.)
Punch Feed Stop Light (Only)
Sense Bit 1-lntervention Required Only)
(If the 2540 is not performing PF R
operations.)
Restart Procedures
1. Remove cards from stacker R 1.
2. Open joggler gate and remove cards from hopper.
3. With joggler gate open, press start key to clear read feed.
4. Locate and correct invalid character(s) in first card in stacker R 1.
5. Place corrected card ahead of cards in stacker R1. Place all cards in stacker R1 ahead of
cards removed from hopper. Place this deck in hopper ahead of cards in file feed magazine.
6. Close joggler gate.
7. Press reader start key.
1. Remove cards from stacker P1.
2. Remove cards from hopper.
3. Open covers and remvoe any jammed cards from punch feed.
4. Press punch start key to clear punch feed.
5. Discard last card punched (2540 will repunch this card automatically).
6. Replace blank cards in hopper and press punch start key. Last card will be repunched
automatically and 2540 enters ready status.
Figure 2-8. Restart Procedures--Standard and PFR Operation (Part 2 of 3)
2025 FEMM (7/69)
2-31
Advertisement
Table of Contents
