Windows Nt; Setting The Printer's Ip Address; Adding The Windows Nt 4.0 Driver On A Windows Nt 4.0 Server Or Workstation - Tektronix Phaser 740 Network Manual

Chapter
10

Setting the printer's IP address

Adding the Windows NT 4.0 driver on a Windows NT 4.0 server
or workstation

Windows NT

The procedures in this chapter are valid for Windows NT version 3.x and 4.x. For
information about driver installation for later versions of Windows NT, contact
Tektronix technical support or visit the Tektronix web site:
www.tek.com/Color_Printers/support
There are three ways to set the printer's IP address:
Use the printer's front panel. For more information, see "General
information on setting IP parameters (front panel)" on page 57.
Use DHCP. For more information, see "Setting IP parameters: DHCP" on
page 66.
Download a PostScript utility file. For more information, see the
README file on the printer's CD-ROM. The README file is in the UTILS
directory.
The Windows NT 4.0 PostScript driver is a PPD-based driver. Follow these
instructions to add or update the Tektronix Phaser PPD for use with
Windows NT 4.0. Adding this support gives your printer access to Tektronix page
sizes, tray selection, TekColor color corrections, and resident fonts.
This update procedure provides printer page-size information for Windows NT
applications. These instructions assume a basic familiarity with Windows NT
operation and terminology. For additional information about Windows NT, refer to
your Microsoft Windows NT documentation.
N
O T E
You may need the Windows NT 4.0 CD-ROM or your printer's software CD-ROM to
complete this procedure.
PhaserShare Networking Manual
99