Advertisement
Step 10
Apply a sufficient amount of marine grade adhesive caulking (figure
the interface between the mounting plate and the hull (figure
Don't apply too much sealant as cleanup can be messy and time consuming.
Dometic recommends a 3/16" bead 360 around the boss of the mounting
plates, near the flange. See figure
Step 11
Secure each bulkhead plate to the hull using the provided #8 x 1" long stainless screws
(figure
, item 3). The screws are designed to work in fiberglass and aluminum hulls.
9
We recommend tightening these screws by hand. Do not overtighten.
CAUTION!
Do not use other screws as the incorrect screw length and/or material
may be inappropriate for this application.
9
2
✗
✓
✗
1
NOTE
Notch should be at bottom center after installation. Figure
10
Field Installed Bulkhead Fitting Kits
TECH TIP
, inset.
9
, item 1) at
8
, item 1).
9
3
, inset.
9
EN
Advertisement
