Advertisement
Field Installed Bulkhead Fitting Kits
Step 7
With the bulkhead fittings on the hose, wrap the split grommet (figure
each hose, between the bulkhead fitting and mounting plate, oriented as shown.
8
1
Step 8
Take time to arrange the hose length out of the hull to the cylinder. Ensure there is
plenty of hose to permit full engine movement at all trim and tilt angles, including
enough length for additional components like a jackplate or engine tiebars.
Step 9
Once you are satisfied with the available hose length, assemble the bulkhead fitting
components as shown in figure
tight. The teeth on the knurled nut must properly engage the mounting plates for
proper retention.
Dry fit installed bulkhead assemblies to the hull prior to applying sealant.
Install all hydraulic components as per the associated Dometic manuals.
After final system proof testing, perform caulking and installation of the hose
bulkhead fittings, issuing as much hose length to the cylinder as required
at STEP 8.
EN
2
. Torque the knurled nut (figure
8
TECH TIP
8
3
, item 2) hand
8
, item 3) onto
9
Advertisement
