Advertisement
Field Installed Bulkhead Fitting Kits
Step 12
With the hose ends secured to the cylinder, slide the bend restrictor (figure
over the hose fitting to secure in place.
WARNING!
Ensure sufficient hose extends through the bulkhead fitting to allow
movement of the cylinder through the entire engine motion in all trim/
tilt positions, including the full range of jackplate positions (if
applicable). It is not recommended to push/pull on the hoses through
the completed bulkhead fitting assemblies. Hose damage may occur.
Step 13
If necessary you can reposition the hose through the bulkhead fitting by removing
the mounting plate and disassembling the bulkhead fitting assembly, then sliding the
hose through the components to the new position. Reassemble the bulkhead fittings
per steps 9 to 11. Some boats may allow access to the installed bulkhead fittings from
the inside of the hull. If so, back off the knurled nut to allow removal of the bulkhead
fitting. Reposition hose as required then re-insert the bulkhead fitting and tighten the
knurled nut as per Step 9.
Items contained in kits
Component
Mounting plate, single
Mounting plate, dual
Bulkhead fitting
Knurled nut
Grommet
Chrome bezel, single
Chrome bezel, dual
Screws
© 2020 Dometic Group. The visual appearance of the contents of this manual is
protected by copyright and design law. The underlying technical design and the
products contained herein may be protected by design, patent or be patent
pending. The trademarks mentioned in this manual belong to Dometic Sweden AB.
All rights are reserved.
EN
HO7100
HO7105
2
2
-
2
2
2
2
2
2
2
-
6
6
HO7200
-
-
1
2
2
2
-
-
-
1
6
, item 5)
3
HO7205
-
1
2
2
2
-
-
6
11
Advertisement
