Advertisement
WARNING!
Do not cut, kink or crush SeaStar outboard steering hose.
NOTICE!
Ensure that the mounting plates will be mounted to a flat, even surface.
Step 1
Determine desired location where the hoses will exit the hull. DO NOT mount below
the waterline of the boat as the bulkhead fitting is not water-tight.
Step2
Use the appropriate template to drill the clearance holes and pilot holes for the
mounting screws. Deburr holes after drilling to ensure there are no burrs that may
chafe or puncture the steering hose. Ensure the screw holes are countersunk to break
the edge and prevent fiberglass cracking under screw load.
Step 3
Arrange the steering hoses so the bend restrictors (figure
each hose) will finish at the cylinder end. Remove dust cap (item 1) then install the be-
zel plate (item 4), mounting plate (item 6) and knurled nut (item 3) onto the helm end
of the hose; orientate as shown. Replace dust cap after passing the hose end through
items 4, 6, and 3.
3
2
1
6
Field Installed Bulkhead Fitting Kits
3
3
6
, item 5, pre-installed on
4
5
EN
Advertisement
