Firmware Update; General Information; Update Procedure - T+A R 2500 R User Manual

Firmware update

General information

For updating the firmware of the R 2500 R there is a convenient method which requires an existing Inter-
net connection
The wiring diagram for the machine is shown in the chapter Connection and wiring.
The following section describes the exact method of updating the firmware in detail.
To avoid malfunctions after updating the R 2500 R, all devices in the system should always be checked for any
j
available updates and installed if they are available.

Update procedure

• The basic requirement is a functioning network with router and access to a broadband Internet connec-
tion; the system must be operating.
• Switch the machine on.
• Call up the System menu by pressing the
• Rotate the SELECT knob on the front panel to select the Device info menu point, and confirm your selec-
tion by pressing the SELECT knob.
• Select the Update menu point by rotating the SELECT knob, then press the SELECT knob to confirm your
choice.
• The select option WEB should now be active (highlighted).
• The firmware update can now be started by pressing the SELECT knob.
• The screen displays the current state of progress of the update.
• Once the update has been completed (duration 10 - 40 minutes) the device automatically switches itself
off and restarts.
• When the machine has restarted, the update is complete.
• To ensure that the update was successful, access the Device Info menu point mentioned above, and
check the new firmware status.
Instead of starting the update process directly on the device, it is also possible to operate the update process
j
via the SRC2 remote control.
44
button on the front panel.