T+A R 2500 R User Manual page 24

Volume after
power on
Display Brightness
(Screen Brightness)
Display mode
Language
Device name
Energy Saver
Network
Device Info
24
Here you can select whether the R 2500 R switches on with the volume selected before
the device was switched off, a maximum permissible volume or always the same volu-
me.
Unchanged
If you select this setting, the device switches on with the volume set before it was swit-
ched off.
Limited
This setting allows you to define a maximum permissible volume level after power-on.
The value can be set under the menu item „Value".
Fixed value
If this option is activated, the R 2500 Ralways switches on with the volume value set in
the menu item „Value".
At this point you can adjust the brightness of the integral screen to suit your personal
preference for normal use.
This menu item offers the choice between three different display operation modes:
• Always on
• Temporary
• Always off
Selecting ‚Temporary' will switch the display is on for a short while each time the
R 2500 R is being operated. Shortly after operation the display will be switched off
again automatically.
In this menu item you define the language to be used for the displays on the screen of
the front panel of the R 2500 R.
The language used for data transferred to the machine, e.g. from an Internet radio sta-
tion, is determined by the supplying device or the radio station; you cannot define the
language on the R 2500 R.
This menu point can be used to assign an individual name to the R 2500 R. In a home
network the device then appears under this name.
The R 2500 R features two stand-by modes: ECO Standby with reduced stand-by current
drain, and Comfort Standby with additional functions, but slightly higher current drain.
You can select your preferred stand-by mode in this menu point:
On (ECO standby):
Active functions in ECO standby mode:
• Power-on at the device itself.
Automatic power-down after ninety minutes without signal (only possible with certain
sources).
Off (Comfort standby):
The following expanded functions are available:
• Unit can be switched on using the app.
• The automatic power-down function is disabled in Comfort standby mode.
• The picture and sound signals at the HDMI 1 and 2 sources are passed on to the
connected TV even if the device is in standby mode.
All network settings can be carried out at this menu point. For a detailed description on
setting up a LAN or WLAN connection please also refer to the section entitled "Network
configuration" on page 27.
At this menu point you will find information on the status of the installed software and
the factory reset.