Installation And Connection; Installation; Connection - T+A R 2500 R User Manual

Installation and connection

Installation

Carefully unpack the device and store the original packaging carefully. The carton and packing material
are specially designed for this device and will be a safe container during any later transports. Set up the
device at a proper place. Please observe all notes on connection and set-up in the chapter Safety notes
(pages 8 and 9).
Please consider the weight of the device. Never place the device on an unstable surface; the machine
could fall off, causing serious or even fatal injury. Many injuries, especially to children, can be avoided if
the following simple safety precautions are observed:
• Use only such items of furniture which can safelybear the weight of the device.
• Ensure that the device does not project beyond the edges of the supporting furniture.
• Do not place the device on tall furniture (e.g. bookshelves) without securely anchoring both items, i.e.
furniture and device.
• Explain to children the hazards involved in climbing on furniture to reach the device or its controls.
When installing the unit on a shelf or in a cupboard it is essential to provide an adequate flow of cooling
air, to ensure that the heat produced by the unit is dissipated effectively. Any heat build up will shorten
the life of the unit and could be a source of danger. Be sure to leave free space of 10 cm around the unit for
ventilation.
If the system components are to be stacked then the amplifier must be the top unit. Do not place any
object on the top cover. The unit must be set up in such a way that none of the connections can be touched
directly (especially by children). Be sure to observe the notes and information in the section ‚Installation
and Wiring'.

Connection

To use the R 2500 R with all its functions and sources, first you have to make some important connections
and/or connect antennas.
The necessary connections are described below:
Do not connect the R 2500 R and the other components to the power supply until all the necessary

connections have been established.
The terminals (marked with the -symbol) can carry high voltages.

Always avoid touching terminals and sockets and the conductors of cables connected to them. Unless
ready-made cables are used, all cables connected to these terminals and sockets must always be deploy-
ed by a trained person.
12