Configuration Using The Wps Function - T+A R 2500 R User Manual

Configuration using the WPS function

• First activate the WPS-function of the Router or Repeater to which you wish the R 2500 R to be connec-
ted. For details please refer the manual of the device in question.
• Start the WPS-Autoconnect function of the R 2500 R within 2 minutes.
• Use the cursor up / down buttons to select the menu point "WPS-Autoconnect", then confirm
your choice with OK - the button.
• After the connection is established, the line Status shows the connected WLAN network.
• Finally select the "Store and exit?" menu point and press the OK - button to accept the settings.
Manual setup of the WLAN connection
• First select the Scan for WLAN menu item and confirm it with the OK - button.
• A list of the WLANs found appears.
• Use the cursor up / down buttons to select the WLAN to which you wish the R 2500 R to be connected,
and confirm your choice with the OK - button.
• Enter the network password (passphrase) and confirm your entry with OK.
• Confirm and store the settings by selecting the item Store and exit? and pressing OK.
• Finally, select the menu item Store and exit? again and confirm the settings with the OK - button again.
Setting up the WLAN connection via the T+A app
For an easy setup of the network connection, the R 2500 R has an access point function. This is automati-
cally activated whenever the device is neither connected to the network via cable nor a WLAN network has
been configured. This state can be restored at any time by resetting the R 2500 R to the factory default
settings (see p. 24 item Device info).
Proceed as follows to set up the device:
Using Android
• Connect the smartphone or tablet PC on which the T+A TA Music Navigator app is installed to the WLAN
access point.
• The name of the network (SSID) starts with T+A AP 3Gen_.... a password is not required.
• Start the app. Permission for standard required.
• The app detects the access point and automatically starts the setup wizard.
• To set up the WLAN, you must go through the individual steps of the app's setup wizard.
• Exit the app and then connect the smartphone or tablet to the previously set up WLAN.
• After restarting the app, the R 2500 R will be automatically searched for.
• Once the R 2500 R has been detected, it can be selected for playback.
Using iOS (Apple)
• The R 2500 R supports the Wireless Accessory Configuration,(WAC).
• Power on the R 2500 R.
• Open the menu for the settings/WLAN on your iOS mobile device.
• As soon as the device is started, you will find under the item Set up new Airplay speaker an entry that
starts with SET UP NEW AIRPLAY SPEAKER R2500R-xxxxxx.
• After selecting this entry, you can select the network to which your R 2500 R can be connected.
• After confirming the selection, the configuration data of the network is automatically transferred to the
device and the R 2500 R connects to the selected network.
(TA Music Navigator)
29