The Configuration For A Wired Ethernet Lan Or Power-Line Lan Connection; Setting The Parameters For A Wired Network - T+A R 1000 E User Manual

The Configuration for a Wired Ethernet LAN or Power-Line LAN connection

Setting the Parameters for a
Wired Network
Menu Point
MAC
Connection state
DHCP
IP
Subnet mask
Gateway
DNS
Store and exit?
Discard and exit?
52
 Connect the R 1000 E to an operational network or Power-Line modem using
the LAN socket on the back panel.
 Switch the R 1000 E on, and select the Streaming Client function by pressing
the  button.
 Call up the Configuration menu as described above. You should now see the
menu reproduced below, displaying the network parameters. In the title line the
message 'LAN' should appear, indicating that the machine is connected to a
wired LAN. If you see 'WLAN' at this point instead, please check your network
connection, and ensure that the network is switched on and operational.
 You can now select the individual menu points and adjust them to match your
network conditions. The illustration below shows the possible button inputs
after each menu item.
: Switching ON / OFF
 / 
(0...9): Numeric input, separating dots are automatically generated;
input limited to valid addresses
(0...9, A...Z): Alpha-numeric input and special characters.
IP - separating dots must be entered as special characters.

The parameters illustrated above are only typical values.
Addresses and settings may require different values for your network.
Description
The MAC address is a hardware address which uniquely identifies your machine.
The address displayed is determined by the manufacturer, and cannot be
altered.
Shows the connection state: WLAN, LAN or not connected.
ON
If your network includes a DHCP server, please select the ON setting at this
point. In this mode an IP address is automatically assigned to the R 1000 E by
the router. The screen shows only the MAC address and the message DHCP
state ON. In this case the address input fields shown in the illustration do not
appear in the menu.
OFF
If your network does not include a DHCP server, please select the OFF setting.
In this mode you must configure the following network settings manually. Please
ask your network administrator for the addresses to be entered for your network.
IP address of the R 1000 E
Network mask
IP address of the router
Name / IP of the name server (optional)
Stores the network parameters, and restarts the R 1000 E with the new settings.
Closes the menu: data already entered is discarded.
Possible entries