Standard Equipment Location - Space Requirements - Xerox DocuPrint 75 Installation Planning Manual

Installation

Standard equipment location - space requirements

4-4
NOTE: Xerox Europe provides its own modems and power
strip.
NOTE: In the USA & Canada only, if installing in a hallway or
exit route, allow a minimum of 44 inches (1118 mm) additional
clearance in front of the printer in order to meet the fire code
regulations.
Figures 4 through 8 in the following section are presented in the
order of preferred placement. The dimensions assume a
movable installation (carpet no deeper than 0.25 inches or 7
mm). Additional access measurements are shown in
The symbols used in the space requirements figures are defined
in Figure 4-4.
Figure 4-4. Symbols used in figures
CPU
Peripherals
Peripherals
Always attempt to place the equipment in the standard location
before selecting any other location.
The preferred location of the equipment is called the standard
location, shown in Figure 4-5.
• CPU on floor, between the printer and the wall
• Monitor, controller modem, keyboard and mouse on top of
the printer
Installation Planning Guide
Table
Printer
The standard location requires:
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Table 4-2.