Adjustable Shelf - BDI CORRIDOR BAR 5620 Instruction Manual

STEP 4. INSTALL BACK PANELS

ADJUSTABLE SHELF

The shelf pins located inside the right compartment
may be repositioned using (T1) Phillips
Screwdriver, allowing you to raise or lower the
Adjustable Shelf to the desired level.
LEVEL CABINET
Once the unit is completely assembled and in its
final position, adjust the levelers using (T3) Open
Mouth Wrench as necessary. If you prefer to have
the doors remain in a fully-open position, partially
extending the two (2) front levelers is desirable.
This action will orient the cabinet back slightly,
preventing the open doors from swinging
towards their closed position.
ADJUSTING THE DOOR GAPS
With both doors closed, check to see if the top
corners of the doors align. If not, dial out the
corresponding front leveler under the door that
is sagging.
EXAMPLE: If the door on the right is low, dial out the
right front leveler to raise the door back into
alignment with the left door.
To move the right door up, dial the front, right leveler out.
To move the left door up, dial the left, front leveler out.
NEED ASSISTANCE? customerservice@bdiusa.com | 9
FINE TUNING ASSEMBLY
PART/DESCRIPTION
T1-PHILLIPS
SCREWDRIVER
T3-OPEN MOUTH
WRENCH
QTY
1
1