Handling Safety; Installation Safety - Grundig GQN1240XN User Manual

Do not touch the plug with wet hands.
•
When unplugging the appliance, don't hold the power cord, but the plug.
•

1.4 Handling Safety

This product is heavy, do not handle it by yourself.
•
Do not hold the product from its door while handling the product.
•
Be careful not to damage the cooling system and the pipes while handling
•
the product. Do not operate the product if the pipes are damaged, and
contact an authorized service.

1.5 Installation Safety

Contact the Authorized Service for the product's installation. To prepare
•
the product for installation, see the information in the user guide and make
sure the electric and water utilities are as required. If the installation is not
suitable, call a qualified electrician and plumber to have them make the
necessary arrangements. Otherwise, electric shock, fire, issues with the
product or injuries may occur.
Check for any damage on the product before installing it. Do not have the
•
product installed if it is damaged.
Place the product on a level and hard surface and balance with the
•
adjustable legs. Otherwise, the refrigerator may tip over and cause injuries.
The product shall be installed in a dry and ventilated environment. Do not
•
keep carpets, rugs or similar floor covers under the product. This may cause
risk of fire as a result of inadequate ventilation!
Do not block or cover ventilation holes. Otherwise, power consumption may
•
be increased and damage to your product may occur.
Do not connect the product to supply systems such as solar power supplies.
•
Otherwise, damage to your product may occur as a result of the abrupt
voltage fluctuations!
The more refrigerant a refrigerator contains, the bigger its installation
•
room shall be. In very small rooms, a flammable gas-air mixture may occur in
case of a gas leak in the cooling system. At least 1 m3 of volume is required
for each 8 grams of refrigerant. The amount of the refrigerant available in
your product is specified in the Type Label.
The installation place of the product shall not be exposed to direct sunlight
•
and it shall not be in the vicinity of a heat source such as stoves, radiators,
etc.
If you cannot prevent installation of the product in the vicinity of a heat
source, you shall use a suitable insulation plate and the minimum
distance to the heat source shall be as specified below.
- At least 30 cm away from heat sources such as stoves, heating
units and heaters, etc.,
- And at least 5 cm away from electric ovens.
DK
Fİ
SV
NO
CZ
SK
RO
5