Test The Printer Connection - Xerox 4850 Installation Planning Manual

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
CREATE DEVICE DESC (PRINTER) (CRTDEVPRT)
Type choices, press Enter.
DEVICE DESCRIPTION.........
DEVICE CLASS...............
DEVICE TYPE................
DEVICE MODEL...............
ADVANCED FUNCTION PRINTING..
AFP ATTACHMENT.............
MESSAGE QUEUE...............
LIBRARY..................
MAXIMUM PENDING REQUESTS...
PRINT WHILE CONVERTING.....
PRINT REQUEST TIMER........
FORM DEFINITION............
LIBRARY..................
REMOTE LOCATION............
LOCAL LOCATION.............
REMOTE NETWORK IDENTIFIER...
MODE......................
TEXT 'DESCRIPTION'.........
4. Test the printer connection – AS/400
Pinging the printer
E-22
Table E-17. Create Device Description (Printer) screen for
OS/400 with V3R2 installed
> XEROXIPS
> *RMT
> *IPDS
> 0
*YES
> *APPC
QSYSOPE
6
*YES
*NOMAX
F1C10110
XEROXIPS
*NETATR
*NETATR
*NONE
*BLANK
Test the printer by one of the following methods to ensure AS/400 is
able to make a connection with the IPS printer:
•
Send a job from the host through PSF to print on the IPS. (Refer
to your IPS Guide to Configuring and Managing the System for
printing procedures.)
•
Ping the printer from your AS/400 system to ensure the AS/400
can establish a connection with the TCP/IP-attached IPS.
To ping the printer to verify a connection can be made, enter the
following command on an OS/400 command line:
PING 'Remote Location'
'remote location' specifies the internet protocol (IP) address of the
IPS printer (refer to the configuration worksheet, earlier in this
section).
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE
*
*LIBL
*LIBL
* Same as DEVICE
DESCRIPTION