Controller Hardware Specifications And Requirements Summary - Xerox 4850 Installation Planning Manual

Controller hardware specifications and requirements summary

Dimensions (depth,
Device width, height)
Host Channel d=15 in. / 40.8 cm
Unit (HCU) h=5 in. / 12.6 cm
(channel- w= 16 in. / 41.6 cm
attached
systems only)
Processor d=16.1 in. / 40.9 cm
w=16.4 in. / 41.7 cm
h= 3 in. / 7.6 cm
Monitor d=6.1 in. / 41cm
w=20 in. / 50.8 cm
h=17.7 in. / 45 cm
4 mm cartridge d=12.2 in. / 31 cm
tape drive w=7.5 in. / 19 cm
h=2.8 in. / 7 cm
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
The following table summarizes the specifications and electrical
requirements of your DocuPrint IPS printer controller hardware
components.
For a summary of printer hardware specifications and requirements,
refer to the "Printer specifications and requirements" chapter of this
guide. Contact your service representative if you have questions not
specifically addressed in this guide.
Table 5-4. 4850/4890 IPS printer controller specifications and
power requirements
Heat
Weight dissipation
26 lbs. 10 N/A
oz. / 12.4
kgs
27 lbs. / 1,100 BTU
12.7 kgs per hours
61 lbs. / 408 BTU
27.7 kg per hour
8 lbs. / ---
6.6 kg
Power requirements
120 VAC within 6 feet;
120 volt at 2 amps or
240 volt at 1 amp
Sun Ultra 2 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 2 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Sun Ultra 60 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 60 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
100-120 ~ VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
100-120/200-240 VAC,
0.8/0.4 amp, 47-63 Hz
Cable lengths
Bus and tag
cables must
conform to host
system
requirements
(200 to 400 ft. /
66.7 to 133.3 m)
and
accommodate
system setup.
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Video cable to
processor:
46 in. / 1.17 m
SCSI cable to
processor or
additional SCSI
device:
28 in. / 71 cm
5-9