Firepower MST 180i Operating Manual page 52

Firepower MST 180i
Positive Welding
Terminal (+)
MIG Torch
polarity lead
not connected
Work Lead
INSTALLATION, OPERATION AND SETUP
(MIG Gun
not shown
for clarity)
TIG Torch
Figure 3-18: Setup for TIG Welding
3-24
Connect to shielding gas
regulator/flow gauge.
Secure the gas cylinder
in an upright position by
chaining it to a stationary
support to prevent falling
or tipping.
Negative welding terminal (-)
50mm- 25mm Adaptor
Note: A Firepower 17V TIG torch with
an 8 pin plug must be used to turn the
weld current on/off via the TIG torch trigger
switch to TIG weld OR a Firepower Foot Control
with an 8 pin plug must be used to turn the
weld current on/off as well as providing
remote control of the weld current.
Art # A-12447
Manual 0-5339