Quick Network Setup (Static Ip); Prerequisites For Manual Setup Of Network Using Static Ip Address; Procedure For Manual Setup Of Network Using Static Ip Address - Xerox WorkCentre 7232 Quick Network Setup Manual

Quick Network Setup (Static IP)

Prerequisites for Manual Setup of Network Using Static IP Address

Note
On startup, the WorkCentre multifunction device defaults to DHCP to obtain its
network configurations, so DHCP must be turned off on the device in order to manually
enter a static IP address.
Before configuring the device, record the following information for use during setup:
TCP/IP Address:
Gateway Address:
Subnet Mask:
DNS Server Address:
Note
To obtain this information, contact your System Administrator.

Procedure for Manual Setup of Network Using Static IP Address

1. Power on the device.
2. Log In/Out, then type the Login ID 11111 and touch Enter.
Press
3. Machine
Press
4.
From the Tools tab, touch the System Settings option.
5.
Touch Connectivity and Network Setup.
6. Touch Protocol Settings.
7.
To enter values for a particular item, select the appropriate item, then touch the Change
Settings button.
8.
When all of the appropriate items have been entered, touch the Save button.
9.
When you have finished configuring the Protocol Settings, touch Close repeatedly until
the Tools tab is displayed.
10. Log In/Out.
Press
11.
Touch Logout to save your changes and exit the System Administrator's Tools mode.
12.
Verify that the device is available on the network by opening a web browser (such as
Internet Explorer) on a networked workstation, and then enter the device IP address in
the format http://xxx.xxx.xxx.xxx (the xxx's represent the device IP address). If the
device is available, you should see a CentreWare Internet Services web page for your
device.
13.
Load the print drivers on the workstations that will be accessing the device.
Copyright © 2007, Xerox Corporation. All rights reserved.
Status.
Quick Network Setup (Static IP)
3