Xerox WorkCentre 6505N User Manual page 93

Performing Manual 2-sided Printing from Tray 1
Notes:
• This method of manual 2-sided printing is only available using the PCL print driver.
• Do not use this method with cardstock or glossy cardstock.
• This method requires the Productivity Kit to be installed in the printer for a total of
768 MB of RAM. For information on your printer configuration and available optional
features, see
• The RAM Disk feature of the printer must also be enabled for you to use this method . For
information on enabling this option, see
1. Load Tray 1 with paper acceptable for use in Tray 1. For details, see
2. In the application you are printing from, open the Print dialog box and select the
WorkCentre 6505 PCL driver.
3. Click the Properties button.
Click the Advanced tab.
4.
5. In the Other Settings section, in the Items list, select Electronic Sort.
In the Electronic Sort field below the Items list, select Off.
6.
7. Click the Paper/Output tab, then do the following:
a. From the Paper Tray list, select Tray 1.
From the 2-Sided Print list, select Flip on long edge (Manual) or Flip on short edge
b.
(Manual).
c. From the Paper Type field, select the paper type.
d. Select any other desired settings, then click OK.
8. In the Print dialog box, specify the pages to print, then click OK or Print to start printing.
Note: You do not need to specify printing odd or even pages. Specify all pages or a page range.
The driver sends the even pages, then pauses the printer so you can insert the printed pages back
into Tray 1.
The Setting Method for Paper Tray 1 Duplex window opens.
Note: Leave this window open until you complete the entire print job. It contains instructions for
reloading the printed pages into the paper tray.
9. When printing is complete, lift the printed pages from the paper tray without turning them over or
around, and place them in the paper tray with the blank sides of the pages facing up.
10. Close the tray.
11. On the printer control panel, press the OK button to resume printing.
Performing Manual 2-sided Printing from the Manual Feed Slot
1. Print the first side of a sheet of paper.
2. Adjust the paper guides in the manual feed slot to fit the printed sheet.
3. Insert the sheet evenly into the manual feed slot with the printed side face down.
Note: If the paper looks skewed after the printer pulls it in, gently remove the paper and insert it
again.
Configurations and Options on page 21.
Enabling Optional Features
Supported Paper
WorkCentre 6505 Color Laser Multifunction Printer
Printing
on page 46.
on page 58.
93
User Guide