Primary/Secondary Master/Slave Udma; Init Agp Display First; Onboard Fdd Controller; Onboard Serial/Parallel Port - TMC MI5VMT User Manual

Primary/Secondary Master/Slave UDMA

These fields allow your system to improve disk I/O throughput by
enabling the Ultra DMA/33 or Ultra DMA/66 feature of your hard
disks. The options are Auto and Disabled.

Init AGP Display First

This field allows the system to initialize first the VGA card in the AGP
slot on the motherboard when system is turned on.

Onboard FDD Controller

Select Enabled if your system has a floppy disk controller (FDC)
installed on the motherboard and you wish to use it. If you install an
add-in FDC or the system has no floppy drive, select Disabled in this
field. This option allows you to select the onboard FDD port.

Onboard Serial/Parallel Port

These fields allow you to select the onboard serial and parallel ports
and their addresses. The default values for these ports are:
Serial Port 1
Serial Port 2
Parallel Port

UART 2 Mode

This field determines the UART 2 mode in your computer. The default
value is Standard.

Parallel Port Mode

This field allows you to determine parallel port mode function.
SPP
EPP
ECP

Onboard Legacy Audio

When this field is enabled, other options of the on board audio in this
setup can be configured. These options included Sound Blaster, SB I/O
Base Address, SB IRQ Select, SB DMA Select, MPU-401, MPU-401
I/O Address and Game Port.
MI5VMT User's Manual
3F8/IRQ4
2F8/IRQ3
378H/IRQ7
Normal Printer Port
Enhanced Parallel Port
Extended Capabilities Port
Chapter 6 BIOS Configuration
57