On-Chip Primary/Secondary Pci Ide; Usb Keyboard Support; Init Agp Display First; Onboard Fdc Controller - TMC TI6NB User Manual

Chapter 6 BIOS and System Setup

On-Chip Primary/Secondary PCI IDE

The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel
separately.

USB Keyboard Support

Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.

Init AGP Display First

This field allows the system to initialize first the VGA card in the AGP
slot on the motherboard when system is turned on.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install an
add-in FDC or the system has no floppy drive, select Disabled in this
field. This option allows you to select the onboard FDD port.

Onboard Serial/Parallel Port

These fields allow you to select the onboard serial and parallel ports and
their addresses. The default value for these ports are:
Serial Port 1 3F8/IRQ4
Serial Port 2 2F8/IRQ3
Parallel Port 378H/IRQ7

UART Mode Select

This field determines the UART mode in your computer. The settings are
Normal, IrDA and ASKIR. The default value is Normal.

Parallel Port Mode

This field allows you to determine parallel port mode function.
SPP Normal Printer Port
EPP Enhanced Parallel Port
ECP Extended Capabilities Port
50 TI6NB Pentium II 440BX ATX Motherboard User's Manual