FiberHome FOSC-220J-C104 Installation Instructions

Installation Instruction for FOSC-220J-C104

Feeder cable sealing

Cut the both sides of the double holes seal ring with a knife, install the sealing

assembly on the mid-span cable in order, then install them into the mid-span cable port.

Install the sealing assembly on the distribution cable in order, then install them into

the distribution cable port.

Table of Contents

Do you have a question about the FOSC-220J-C104 and is the answer not in the manual?

Page 1 Installation Instruction for FOSC-220J-C104 Feeder cable sealing Cut the both sides of the double holes seal ring with a knife, install the sealing assembly on the mid-span cable in order, then install them into the mid-span cable port. Distribution cable sealing Install the sealing assembly on the distribution cable in order, then install them into the distribution cable port.
Page 2 Installation Instruction for FOSC-220J-C104 Strip the cut feeder cable, access it into the splicing tray with bare fiber protective tube, splice the fibers of the main cable and distribution cable in the splice tray directly. Direct splice Mid-span If necessary, the splitter can be mounted in the tray with the special slot. The input and output of the splitter are spliced with bare fibers of the feeder cable and the distribution cable, respectively.
Page 3 Installation Instruction for FOSC-220J-C104 Wall-mounted Drill 4 holes on the wall by using a percussion drill at the marked points. Hammer the plastic expansion sleeve completely into the drilled holes. Fit the mounting bracket on the wall with screw, then fix the dome on the...
Page 4 Installation Instruction for FOSC-220J-C104 Pole-mounted Fit the dome to the pole with the hoop. Put the hoop in the mounting bracket. Cable messenger-mounted Install the clasps onto the 2 mounting holes at the back of the box. Hang the box onto the cable messenger and then secure it with the screws.