Xerox Document Centre 50 Installation Manual page 75

11
Click on the TCP/IP tab.
12
Review and edit any fields, if necessary. If you enable DHCP, be sure to
save the new Configuration Report that will print approximately 5 minutes
after you power off and power on the copier/printer (in Step 12 below),
since the IP Address may have changed. You will need the new address
the next time you access the settings.
13
When you have finished entering the Settings data, click Apply, OK and
then Exit.
14
Power off and power on the copier/printer. Allow at least 30 seconds
between powering off and powering on the printer. A Configuration
Report will print in approximately 5 minutes. The information on the
Configuration Report can be very helpful in completing the network
installation and troubleshooting problems with your copier/printer.
15
Continue with Step 3 Print a Test Page.
Step 2. Customize Printer Connectivity Settings 4-9