Configuration Tab Settings; Settings - Xerox CopyCentre 133 User Manual

Postscript

Hide thumbs Also See for CopyCentre 133:

Table of Contents

2 Operation with Windows 95/98/Me

Configuration Tab Settings

This section describes the settings of the Configuration tab.

Select the function that you want to set in the Features List and change the settings in the

Change box below.

NOTE: You can restore defaults by clicking [Restore Defaults].

NOTE: The settings that can be selected vary depending on which options have been

installed. Change these settings only after confirming that the option settings are

complete. See Options Tab Settings on page 14.

Image Enhancement - Specifies whether or not to use the Image Enhancement function.

Selecting [On] smooths out boundaries when printing. This reduces jagged edges by artificially

increasing the resolution of the image. When printing a bitmapped image composed of coarse

halftone dots, smooth color gradation is impossible in certain situations. In this case, select [Off].

Draft Mode - Specifies whether or not to reduce the amount of toner used when printing drafts.

When [On] is selected, the overall printed color becomes lighter. This is best for printing

documents when high print quality is not necessary.

Print Mode - Specifies whether to give priority to the print speed or the image quality.

Stapling - Specifies whether or not to staple printed documents and the position of the staple.

You can staple 2 to 50 sheets of 80 g/m

or lighter paper.

Xerox WorkCentre/WorkCentre Pro 123/128/133 PostScript® User Guide

Table of Contents