Table of Contents
Advertisement
Figure 119. Canbus I/O panel installed on front I/O panel
11. Install the Canbus mPCIe module on the motherboard. Use the two M2.5 x 6L screws in the corners of the module, as shown
in the following figure.
Figure 120. Canbus mPCIe installed on motherboard
12. Connect the cables from the Canbus ports to the Canbus mPCIe module. Use a cable tie, as shown with a red circle in the
following figure.
70
Installation procedure for 2x Canbus uFM module
Advertisement
Table of Contents
