Table of Contents
Advertisement
Table 3. Expansion module packing list - 4G (continued)
Item
Antenna
4G label
4G heat sink
Thermal pad
Table 4. Tools needed
Tool
Phillips head screwdriver
Needle-nose pliers
Nut drivers
Steps
1. Remove the eight screws from the bottom panel of the EGW-5200, as shown in the following figure, and remove the bottom
panel.
Figure 12. Bottom panel screw locations
2. Remove the screws and nuts from the inside of the bottom panel, as shown in the following figure. Hold the nuts from inside
the panel while unscrewing. Discard these four sets of screws and nuts.
12
Installation procedure for 4G expansion module
Quantity
2
1
1
1
Notes
Small size
—
4.5 mm, 5 mm, 5.5 mm, 8 mm
Notes
-
-
-
-
Advertisement
Table of Contents
