Sharp UX-1300 Operation Manual page 63

REMOTE OPERATIONS
messages, you can do any of the follow-
ing:
e Erase all messages: To erase all of
the messages in the box, press "3",
"3, and ar: a
e Repeat playback: To listen to your
messages again, press "7" and "#".
e Perform other operations: You can
enter any of the commands described
in the following section, "Other remote
operations".
e Hang up: If you do not erase your
messages first, they will be saved and
any new messages will be recorded
after them. If you want the
UX-1300/1400 to resume normal
operation immediately, press "3¢"
twice before hanging up (in some
cases, particularly when the Transfer
function is used, the UX-1300/1 400
may not accept new calls for one or
two minutes after you hang up unless
you first press "%" twice).
Comments:
®@ When entering a command, do not pause longer than 10 seconds between each
digit. If you do, a 4-beep error signal will be issued and the digits entered up to
that point will be disregarded. In this case, re-enter the command from the
beginning.
USING THE ANSWERING MACHINE 4-9