Mitel 6930 User Manual page 220

A F
DDITIONAL EATURES
Phone Feature
Last Call Return
Speed Dial
Conference
Transfer
Park
Voicemail
Outgoing Redial
Dialing
Caller ID
Factory Default
:
NOTE
If you specify a value of 0 for the Preferred Line parameter, it disables the preferred line focus feature.
1.
If you specify a value of 0 for the Preferred Line Timeout parameter, the phone returns the line to
2.
the preferred line immediately.
P
REFERRED
Preferred Line Behavior
The phone switches back to the focused line
immediately after the call ends.
The line is already specified when the speed dial
is created. The phone switches back immediately
after the call ends.
For incoming calls, the phone switches back
immediately after the call ends.
For incoming or outgoing calls, the current
behavior is that the same line used to transfer the
call does not change. For incoming calls, the
phone switches back immediately after the call
transfers.
The phone switches back immediately after the
call ends.
The phone switches back immediately after the
call ends.
The phone switches back immediately after the
call ends.
For incomplete dialing on a non-preferred line,
the focus does not change if some digits are
entered.If no digits are entered or digits were
cleared, the focus changes to preferred line after
the time out has passed without activities.
If the Switch UI Focus To Ringing Line parameter
is disabled, the User is able to see the Caller ID
when the phone switches the focus to the ringing
line.
Factory default and recovery mode clears the
preferred line and preferred line timeout
parameters, and the phone operates in a
non-preferred line mode.
L P L
INE AND REFERRED INE
T
IMEOUT
209